Service Documents

MX INSTRUCTION

Issue link: https://docs.hic.us/i/445631

Contents of this Issue

Navigation

Page 102 of 263

90 To trim thread Chapter 5 QS07 2-6. To change thread trim timing (ATH Start Timing) This function applies to single head machine only. Its purpose is to improve thread trimming by changing moving timing of the thread trimming knife. 2-6-1. Explanation on the screen 2-6-2. How to operate The following is an example that ATH drive start timing is set to "5 °". (1) To set to main screen (2) To press F2 key while pressing SET (3) To press F2 key (4) To select ATH drive start timing This machine was shipped after being set to optimum values. To change these values, consult the distributor. Some operating condition could cause occurrence of fault in thread trimming. 0 Timing to start moving thread trimming knife (Value is of main shaft angle) 4 ATH Drive Start Timing -10 Fast 10 Slow Start moving of the thread trimming knife ! CAUTION SET + F2 screen will be displayed. 4 ATH Start Timing 0 5

Articles in this issue

view archives of Service Documents - MX INSTRUCTION