Issue link: https://docs.hic.us/i/445631
94 To stop the machine Chapter 5 PT10 4. To stop the machine 4-1. To stop the machine automatically when reaching the set value (Preset Halt) 4-1-1. Explanation on the screen [a] The machine will stop when counting reaches the number of set stitches (display of 1D2). [b] The machine will stop when embroidery stitch length reaches the set length (display of 1D2). [c] The machine will stop when the number of designs reaches the set numbers (display of 1D2). [d] The machine will stop when counting reaches the number of set stitches (display of OIL). When automatic lubrication system is set to "YES", it will not be displayed. [e] The machine will stop short of the end code by one stitch (display of 1D2). YES: To stop Since embroidery is not finished, it is possible to perform frame back. NO: Not to stop [f] Quantity of beads attached to Lochrose embroidery device (option) at left When the equipped beads run out, the machine stops (display of 1D5). To disable this function, select "NO". This setting will be displayed when "Lochrose embroidery device" is set as "L" or "L + R" (p.193). [g] Quantity of beads attached to Lochrose embroidery device (option) at right The contents are same as above. 6 Preset Halt C Stitch 0 0 0 10 NO 0-999999[st] Data 0-99999[cm] Design 0-999[Designs] Lubrication 0-99*10000[st] Just before YES/NO 300 300 Lochrose (L) Lochrose (R) [a] [b] [c] [d] [e] [f] [g] To stop at number of stitches (1 stitch unit) To stop by stitch length To stop by number of designs To stop at number of stitches (10000 stitch unit) To stop just before end of design To stop by beads quantity at left To stop by beads quantity at right end code