Issue link: https://docs.hic.us/i/445631
Safety Precautions 4 Chapter 1 PT10 1-2. Caution When operating the machine, the following items must be observed strictly to prevent accidents resulting in injury or death and property damage. Use the machine with about 70% of the maximum speed as "operation for total fitting" for about two weeks after installing this machine. By performing operation for total fitting, life of the machine will become longer, which will be useful to avoid unexpected troubles. Do not use bent needles or needles that are not suitable for the material. Be sure to turn OFF the power switch after working, and turn OFF the primary power supply. Do not put things on the table. This machine uses strong magnet. This machine including magnet should not be accessed to a cellular phone, an analogue watch, a floppy disk, a magnetic tape or a magnetic ticket. In addition to full-time leak current, leak electric current generated by harmonics and surge flows in the power cable of the machine. For this reason, if selection and installation of breaker of leak current and leak current relay used for the factory are not correct, malfunctioning of the machine may occur. Regarding connection of power cord, observe the following items. Use a breaker of electric current leakage and leak current relay for which measures are taken against harmonics and surge. If you use conventional breaker and relay without such measures, select with sufficient leak current capacity to fill up leak current by harmonics and surge. (In this case, leak current must be controlled constantly satisfactorily.) Regarding capacity of electric current leakage for leakage breaker and leak current relay necessary per machine, consult your local Tajima distributor. For actual product names of breaker of electric current leakage and leak current relay for which measures are taken against harmonics and surge, please consult your local Tajima distributor or electric engineers. To prevent the machine from property damages (the power decline of the main shaft motor, etc., stop position error and its color change error, design displacement, etc), one embroidery machine should be connected to one no fuse breaker in regard to connecting power harness. ! CAUTION