Issue link: https://docs.hic.us/i/445631
163 To move the frame to the position registered Chapter 6 1 2 3 4 5 6 7 8 9 10 11 SQ01 5. To move the frame to the position registered 5-1. To move the frame automatically at the start and the end of embroidery (Automatic Offset) This is the setting to move the frame automatically so that replacement of the frame and the fabric to be stretched can be performed easily. Perform this setting after data set. Setting contents here will be added in a design. So, when you embroider this design next time, setting again will be unnecessary. The following is an example of movement when the setting of "Automatic Color Change (AC) / Auto Start (AS)", "Automatic Thread Trimming" is "YES". (1) At the start of embroidery, the frame will pass from the offset start position [A] through the offset middle position [B] and move to the design start position [C], then the embroidery will start. (2) When embroidery is finished, the frame will pass from the design end point [D] through the offset middle position [B] and return to the offset start position [A]. 5-1-1. Explanation on the screen [a] Offset middle position [B] The position where the frame will pass. This position is optionally set. Set it when embroidered material hits the machine during the frame travel. [b] Offset start position [A] The position where the frame has come to the front. Changing the frame and the fabric to be stretched will be performed here. [A] [c] [B] [B] Embroidery starts Completion of embroidery [D] [A] 5 Automatic Offset B OF1 X [mm] 0 Y [mm] 0 OF2 X [mm] 0 [mm] 0 Y Previous 0 0 0 0 [a] [b] Offset middle position [B in the figure above] Offset start position [A in the figure above]