Service Documents

MX INSTRUCTION

Issue link: https://docs.hic.us/i/445631

Contents of this Issue

Navigation

Page 227 of 263

215 Countermeasure when the machine stopped Chapter 9 1 2 3 4 5 6 7 8 9 10 11 RR07 1-3. Stop due to malfunction It is displayed in red on the screen. It is caused by card, harness or communication error. If the below code No. is displayed, consult the distributor. B04 USB memory is not inserted. Insert. BC1 Design tried to input is not in design spooler. Check the condition of design spooler. BC2 The same file name exists in USB memory. Change the file name. BC5 Insufficient remaining capacity of USB memory Replace with a USB memory with enough remaining capacity. BF1 At network connection to host PC, IP address was not obtainable from DNS server. Check IP address of DNS server. Correct "IP Setting.ini" file. Check operating condition of DNS server. BF2 The contents of "IP Setting.ini" file for network setting was incorrect Correct the contents of "IP Setting.ini" file. 5B1 It is not possible to input data due to abnormal contents of configuration in TCF design. Check the design. 5C1 Data set was performed without frame origin memory after installation of software. The machine was stopped during operation of frame origin memory. Perform frame origin memory. 5C2 Machine was started during moving up/down of sequin device. Start the device after completion of up/down. 5C3 Setting error of sequin device III Check the setting of panel. 5C6 General external device is operating. Operate the machine after general external device is stopped. No. Stop Factor How to restore 311 Encoder A signal does not change for 5 seconds. Abnormality of motor, motor belt (It is not dis- played for the single-head machine.) Check connection of the encoder signal lines. Check excitation of the main shaft driver. Check the motor or motor belt. 312 Fixed position signal (Main shaft Z signal) does not change during operation. Press the E key. Check the main shaft motor or the photo-interrupter card.When recovery is impossible, replace the main shaft motor or the photo-interrupter card. No. Stop Factor How to restore Information error of head number The setting conflicts with the actual [3C3] "Reset" >>E Code No. Stop Factor

Articles in this issue

view archives of Service Documents - MX INSTRUCTION