Service Documents

MX INSTRUCTION

Issue link: https://docs.hic.us/i/445631

Contents of this Issue

Navigation

Page 39 of 263

27 How to use each part Chapter 2 1 2 3 4 5 6 7 8 9 10 11 SQ01 2-5. Table offset switch This operation facilitates threading by moving the frame to the rear (the table offset position) at thread breakage. Pressing this switch will move the frame to the table offset point. This function targets the model equipped with table offset switch. 2-5-1. How to operate The machine stops when thread is broken. Since the movement of the machine differs depending on the switch operation, perform any one of the following operations. The frame moves in the same way even when the thread does not break. (1) Press the switch and release it immediately. => The frame will move to the rear. (2) Press the switch for two seconds or more. => After trimming threads of all heads, the frame will move to the rear. Since the movement of the machine after passing the thread differs depending on the switch operation, perform any one of the following operations. (1) Press the switch and release it immediately. => The frame will return to the original position. (2) Press the start switch, or move the bar switch to the right. => The frame will return to the original position and the machine will start operation. (3) Press the stop switch or move the bar switch to the left. => The frame will return to the original position and the machine will perform Frame Back/ Forward.(p.74) When performing this operation, do not put your hands etc. on the machine table. Moving frame could injure you. Table offset switch When changing table offset position, refer to the detail page (p.168). Table offset position Table offset switch ! CAUTION

Articles in this issue

view archives of Service Documents - MX INSTRUCTION