Service Documents

MX INSTRUCTION

Issue link: https://docs.hic.us/i/445631

Contents of this Issue

Navigation

Page 64 of 263

52 Registration of a design into the machine memory Chapter 4 PT10 3-2-4. How to use a bar code reader during machine operation Read the bar code of the next embroidery design by a bar code reader. (Pre-reading of the next design) The preread design is set at the end of the current embroidery design, and then a yellow bar will be displayed. When the following operation is performed, the yellow bar will disappear. (a) When operation on the panel is performed (b) When the machine is started/stopped (c) When the power is turned ON again There are following conditions for prereading design. (a) Prereading is available in one design only. (b) When reading the bar code plural times during operation, the design read finally will be selected. (c) When embroidery of a design is interrupted during the operation and the data of another design is set, a preread design will be deleted. (d) When embroidery of a design is interrupted during the operation and the data of a preread design is set, read the bar code again. (e) When frame forward is performed at the design while embroidering and the end code is output, the data of a preread design will not be set. TAJIMA_W 14117 Yellow bar

Articles in this issue

view archives of Service Documents - MX INSTRUCTION