Issue link: https://docs.hic.us/i/445631
66 Decision of a design start position Chapter 4 QS07 5-4. To check if a design fits in an embroidery space (Trace) Since the frame moves according to the size of the frame, you can check if the design fits in the embroidery space. 5-4-1. Explanation on the screen 5-4-2. How to operate The following is an example when executing trace. (1) To open screen When performing this operation, do not put your hands etc. on the machine table. Moving frame could injure you. 1 2 3 4 5 6 7 Start position of design The number in the left picture indicates the orbit of the frame. After completion of trace, embroidery from that position is possible. When repeat is set The machine will trace the whole designs after tracing the first design. When automatic offset is set The machine traces according to setting. D1 /Low/High Needle position 15 1 Trace Speed of frame travel Low: Low speed High: High speed -: Not to execute Current needle bar No. The frame moves on the basis of this needle bar. ! CAUTION 1 Trace