Service Documents

MX INSTRUCTION

Issue link: https://docs.hic.us/i/445631

Contents of this Issue

Navigation

Page 94 of 263

82 To trim thread Chapter 5 SQ01 2-2. To trim thread automatically (ATH) It is the setting to trim thread. 2-2-1. Explanation on the screen [a] To trim thread automatically YES: To trim NO: Not to trim thread [b] Length of remaining upper thread after thread trimming (1 in the right figure) When upper thread remains on the fabric, select the value of "-". If sewing is impossible due to short of remaining length of upper thread, select the value of "+". When "N" is displayed, the value differs in each needle bar. Regarding the setting of needle bar unit, refer to the detailed page.(p.109) [c] Number of lowering the needle bar by slow operation at start after thread trimming or after data set [d] The number of return stitches at start of sewing When "N" is displayed, the value differs in each needle bar. (p.109) F2 YES 9 ATH YES/NO N -8 4 2 Return Stitches NO 1/2/T0/T1/T2/NO Return Stitch Length N A A/B/C/D Thread Trim Length 9 +8 Tie Stitches Tie Stitch Length N 0.6 2.0 [mm] 0.4 2.0 [mm] [b] F2 9 ATH B A/B Hook Next page [c] [d] [e] [f] [g] [h] [a] To trim thread automatically Remaining length of upper thread Number of lowering needle bar at slow operation Return Stitches Return Stitch Length Tie Stitches Tie Stitch Length Thread holder Inching after ATH 1 -8 +8 Short Long 0

Articles in this issue

view archives of Service Documents - MX INSTRUCTION