Issue link: https://docs.hic.us/i/445637
To adjust finishing of sewing 105 1 2 3 4 5 6 7 8 9 10 11 Chapter 5 SQ01 7-3-2. Explanation for operation The following is an example that stitch length to jump automatically is set to "6.0". (1) To open screen (2) To select stitch length to perform automatic jump 7-4. To change stitching condition in every needle bar (Setting in units of Needle bar) 7-4-1. Explanation on the screen 2 Auto Jump 6.0 Set 3 Setting in units of Needle bar F1 Needle No. Revolution Limit Thread Detection Automatic Thread Trimming (ATH) 900 rpm Upper thread 2 0/1/2/3/4 Under (Unit) 4 0/2/4/6/8 Under (Step Ratio) 80 30 100[%] +3 -8 +8 Return Stitches 2 1/2/T0/T1/T2/NO [b] [c] [d] [e] [f] [g] [a] 3 Setting in units of Needle bar Set F1 Needle No. Next page Needle bar No. Number of upper thread breakage detecting times Number of under thread breakage detecting times Sensitivity of [d] described above Remaining length of upper thread Return Stitch Length Thread Trim Length Maximum speed 0.4 [mm] 2.0 [i] Tie Stitch Length 0.6 Tie Stitch Length 0.6 [mm] 2.0 [h] Return Stitch Length 0.6 Return Stitch Length