Service Documents

TEMX INSTRUCTION 1.2015

Issue link: https://docs.hic.us/i/445637

Contents of this Issue

Navigation

Page 126 of 247

To increase embroidering efficiency 114 Chapter 5 QS07 8. To increase embroidering efficiency 8-1. To change number of lowering needle bar at slow operation (Number of inching times at start) This function targets slow operation when the machine stops in the middle of embroidery and then the machine restarts. Regarding the number of lowering the needle bar by slow operation at start after thread trimming or after data set, refer to the detail page. (p.78) 8-1-1. Explanation on the screen 8-1-2. Explanation for operation The following is an example that the number of Start Inching is set to "3". (1) To open screen (2) To select number of lowering needle bar at slow operation 8-2. To collect up frame moving amount of consecutive jump stitches in a batch to feed the frame all at once (Jump code combination) This function corresponds to the multi-head machine only. It reduces the number of stitches by combining frame moving amount of consecutive jump stitches (up to 5 stitches) and by feeding the frame all at once. 8-2-1. Explanation on the screen 4 Number of lowering needle bar at slow operation 3 Main Shaft Inching 3 Main Shaft Inching 4 3 NO YES: To set NO: Not to set 5 Jump Code Combination

Articles in this issue

view archives of Service Documents - TEMX INSTRUCTION 1.2015