Issue link: https://docs.hic.us/i/445637
To move the frame to the position registered 161 1 2 3 4 5 6 7 8 9 10 11 Chapter 6 SQ01 5-2. To move the frame automatically at the start, in the middle and the end of embroidery This function is the setting to move the frame automatically so that replacement of the frame, works for applique and change of fabric to be stretched can be performed easily. The following is an example of movement when the setting of "Automatic Color Change (AC) / Auto Start (AS)" and "Automatic Thread Trimming" is "YES". (1) At the start of embroidery, the frame will pass from the offset start position [A] through the offset middle position [B] and move to the design start position [C] by the operation of the bar switch or the start switch (described as switch operation hereinafter), then the embroidery will start. (2) During embroidery, the frame will pass from the color change point [D] through the offset middle position [B] and return to the offset start position [A]. After performing works for applique here, the frame will pass through the offset middle position [B], move to the color change point [D], then start embroidery by switch operation. (3) When embroidery is finished, the frame will pass from the design end point [E] through the offset middle position [B] and return to the offset start position [A]. 5-2-1. Explanation on the screen [A] [C] [B] [B] Embroidery starts During embroidery [E] [A] Completion of embroidery [D] 2 Needle Bar Selection 1 2 3 4 5 6 5 3 4 2 1 3 B Offset mark After step 2 is finished, the frame will return to the offset start position [A] automatically. To move the frame, the setting of "Automatic offset" is necessary. (p.159) If "Automatic Offset" is not set, the frame will move to the design start position [C].