Issue link: https://docs.hic.us/i/445637
Countermeasure when the machine stopped 200 Chapter 9 PT10 1. Countermeasure when the machine stopped When the machine stops during embroidery, a code No. indicating stop factor will be displayed on the screen (the illustration below is an example). Restoring method differs depending on the code Nos. described. 1-1. Normal stop It is displayed in green on the screen. It is not a stop by abnormality of the machine. The list below also includes code Nos. which are not displayed (common to TFMX, TFMS and TEMX-C). No. Stop Factor How to restore 1B1 Stop by frame stepping code Perform "Start operation" or "Frame back/ forward operation", or press any operation key (excluding manual frame travel key) to continue operation of the machine. 1B2 Stop by color change code 1B3 Stop by end code 1B4 Stop by thread trimming code 1B6 Stop by automatic color change (free setting) offset code 1B8 Stop by temporary stop code 1C1 Stop by stop switch during frame stepping Start to the machine. Stop by stop switch during trace To start the operation again, press SET key. To reset the setting, press E key. Do not turn OFF the power during display of 1C1. It may not possible to continue embroidery if the power is turned OFF. 1D1 Stop at all-head sewing start point after frame back Start the machine and continue embroidery. 1D2 Stop by preset halt (except oil, lochrose) Press the E key. 1D3 Stop by moving up of zigzag cording device 1D5 Stop by Preset halt (run out of beads) OIL Preset halt (Oil) Lubricate to the necessary spots, and press E key. [1D2] "Reset" >>E Preset halt Stop by Preset halt setting Code No. Stop Factor