Service Documents

TEMX INSTRUCTION 1.2015

Issue link: https://docs.hic.us/i/445637

Contents of this Issue

Navigation

Page 213 of 247

Countermeasure when the machine stopped 201 1 2 3 4 5 6 7 8 9 10 11 Chapter 9 QS07 1-2. Abnormal stop It is displayed in red on the screen. The trouble will occur when the movement of the machine comes off from normal position etc. No. Stop Factor How to restore 211 The main shaft has stopped deviating from the fixed position. Return the main shaft to the fixed position. Check the main shaft fixed position sensor. 212 The Zigzag Cording Device was tried to move up/ down with the needle bar lowered. Do not move up/down the Zigzag Cording Device. 221 (*) The embroidery frame moved to the travel limit position (left) (-X direction). Move the frame manually so that embroidery can be performed within the set range. *Only the model that has limit switch at drive system is applicable. 222 (*) The embroidery frame moved to the travel limit position (right) (-X direction). 223 (*) The embroidery frame moved to the travel limit position (front) (+Y direction). 224 (*) The embroidery frame moved to the travel limit position (rear) (-Y direction). 225 The frame move to the limit position during trace. Press the E key. Check the current frame position. The frame moved to the software limit position during trace. Press the E key. Check setting range of software frame limit. 228 Table up/down operation was performed when the frame was positioned at the front. Move the frame to the rearmost position. 229 The machine was stopped during Power resume. Perform Power resume again. 251 Oil of lubricating pump is lacking. Lubricate to the lubrication tank. 258 Upper dead point sensor error (Sequin device III only) Check the sensor. 259 Lower dead point sensor error (Sequin device III, zigzag cording device) Check the sensor. 25A Sequin color change sensor error (Sequin device III only) Check the sensor. 291 Upper thread breakage is detected. Check thread. TC sensor card error Replace TC sensor card. Wrong setting for optional device Check the setting for option. [2C2] "Reset" >>E Code No. Stop Factor

Articles in this issue

view archives of Service Documents - TEMX INSTRUCTION 1.2015