Issue link: https://docs.hic.us/i/445637
To register a design in the memory of the machine 50 Chapter 4 PT10 3-2-4. How to operate (To use bar code reader during operation) During working, read the bar code of a design to embroider next by a bar code reader. (A read design is called Pre-reading design.) Currently, at the end point where embroidering design is finished, a pre-reading design is set, then yellow bar will be displayed. When the following operation is performed, the yellow bar will disappear. (a) When operation on the panel is performed (b) When the machine is started/stopped (c) When the power is turned ON again There are following conditions for pre-reading design. (a) Pre-reading is available in one design only. (b) When reading the bar code plural times during operation, the design read finally will be selected. (c) When a design embroidering is interrupted during the operation and the data of the other design is set, a pre-reading design will be deleted. (d) When a design embroidering is interrupted during the operation and the data of a pre-reading design is set, read the bar code again. (e) When frame forward is performed at the design while embroidering and the end code is output, the data of a pre-reading design will not be set. TAJIMA_W 14117 Yellow bar