Service Documents

TEMX INSTRUCTION 1.2015

Issue link: https://docs.hic.us/i/445637

Contents of this Issue

Navigation

Page 80 of 247

Checking items before embroidering 68 Chapter 4 SQ01 6-2. Embroidery head Check the position of the following tension base switch, the needle bar suspension lever, the middle thread guide adjusting lever before embroidering. When the head to embroider is under the following condition, embroidering is possible. Single-head machine: In the state that the tension base switch is ON Multi-head machine: In the state that the tension base switch and the needle bar suspension lever is ON (1) Tension base switch This switch will suspend the head electrically. The switch manipulation during operation of the machine is invalid. Even if the switch manipulation is performed, it will become effective after the machine stops. Tension base switch Green Red Unlit Lit OFF Thread breakage indicator lamp Lit in green In the state of embroidery possible Unlit In a state of suspending embroidery (needle bar will not move down) Blinking in green [*1] *1: Multi-head machine only Frame back section at the head without thread breakage. The lamp at the head without thread breakage blinks in green during frame back. Regarding frame back, refer to the detail page (p.71). Lit in red Upper thread breakage Blinking in red Under thread breakage

Articles in this issue

view archives of Service Documents - TEMX INSTRUCTION 1.2015