Issue link: https://docs.hic.us/i/1260917
To adjust finishing of embroidering 102 Chapter 5 RR06 [a] Needle bar No. applied to sewing condition Perform the following setting for this needle bar. [b] Maximum speed [c] Setting how many consecutive detections of upper thread breakage are regarded as thread breakage 0: Not to stop even if upper thread breaks When idling the machine, set "Upper" and "Under (Unit)" to "0". 1, 2, 3, 4: To stop if upper thread is broken When selecting "3", the thread breakage will be detected after upper thread breaks three times continuously. The relationship between the number of detecting times and sensitivity is shown as follows. [d] Setting how many consecutive times of detection of "under thread (ratio)" of [e] are regarded thread breakage to stop the machine 0: Not to stop even if under thread is broken When idling the machine, set "Upper" and "Under (Unit)" to "0". 2, 4, 6, 8: To stop if under thread is broken When selecting "4", the thread breakage will be detected after under thread breaks four times continuously. The relationship between the number of detecting times and sensitivity is shown as follows. [e] Set sensitivity of [d]. Change this value according to the type of fabric and thread to use. It enables to prevent mis-detection. 30 to 100: To stop if under thread is broken The relationship between detecting ratio and sensitivity is shown as follows. 1 High 4 Low 2 3 [Sensitivity] 2 High 8 Low 4 6 [Sensitivity] 30 Low 100 High [Sensitivity]