How to use each part
16
Chapter 2
SQ06
2-2. Emergency stop switch
The emergency stop switch is equipped as a measure for safety. Pressing this switch will lock the switch and
stop the machine.
[Process after pressing emergency stop switch to lock release]
(1) Press the emergency stop switch.
The switch will be locked, and the machine will stop due to power shut off. However, the power switch is
still turned ON.
(2) Wait for five seconds or more, and turn the switch clockwise. (Lock release) The power will be turned ON.
(3) The screen of "Power Resume" may appear depending on the machine condition. Therefore, execute
according to the screen display.
Wait for five seconds or more after pressing the emergency stop switch until releasing
lock. Otherwise, when turning ON the power again next time, the software may not start
up normally.
After releasing lock, the machine will be turned ON and be in the state of standby. When
performing the maintenance work in this state, pull out the power cord from the inlet. High
voltage electric current flows in P.C. board inside the machine so that it could cause
electric shock.
CAUTION
!
