To move the frame to the position registered
156
Chapter 6
SQ01
5-1-2. How to operate
The following is an example of executing Automatic offset.
(1) To decide an embroidery design (to perform data set)
(2) To move the frame to the design start position [C]
(3) To open screen
(4) To decide OF1 (Offset Middle Position [B])
(5) To decide OF2 (Offset Start position [A])
To cancel setting for Automatic offset, set values of OF1 and OP2 described above to "0".
When performing this operation, do not put your hands, etc. on the table. Moving the
frame could injure you.
At the start and the end of embroidery, do not put your hands etc. on the table. Moving
frame could injure you.
CAUTION
!
5 Automatic offset
The current frame position will
be memorized as design start
position [C] when SET key is
pressed.
-60
150
The frame will move.
-20
300
The frame will move.
