Issue link: https://docs.hic.us/i/1260917
Screen display 25 Chapter 3 SQ06 1-5. Design confirmation screen It is possible to check the setting content of the design to embroider from now and the occurrence record of stop factors (Error Stack). To switch to the design confirmation screen, press i key. Pressing again i key will switch to the next screen. To return to the original screen, press E key. i key E key Current position Stitch Counter Stitch length Design counter Offset Data conversion Rotation Reverse Repeat M.Repeat 57.0 -56.8 95.2 -7.2 (From Start Point) 1/ 10 3. 10. 5. 7. 2. 7 8. 4. 1. 9. 80 10 150.0 pp 185.0 90.0 TAJIMA_W 80 0 10 -130.0 Function Step 1 4 3 5 10 2 Error Stuck 14 1000 rpm 600 rpm 43210 st 280 Cap 2 YES YES NO YES 3 4.0 mm YES 30 +2 NO 4 NO Maximum RPM Min. Revolution Total Stitch Counter Frame Start Timing Stop at Lower D.Point Frame Type 12 13 6 7 8 9 11 Upper thread detection Under thread detection (unit) Under thread detection (step ratio) Auto Color Change (AC) Auto Start (AS) A.S. after Auto Data Set Auto Origin Return Jump Convert Auto Jump ATH Thread trim length Return Stitches (ATH) Tie stitches M.shaft Inching after ATH 70% 4 1. Design (data set design) to be embroidered from now 2. File name 3. Design size : Design Start Point (starting position of design) 4. Total stitch number of design 5. Current frame position Distance from design start point 6. Current number of stitches 7. Current stitch contents 8. Number of times of embroidering this design continuously 9. Step (p.48) 10. Scaling up/down/reversion of design 11. Design repetition 12. Current setting contents 13. It indicates the next page exists. Pressing key will scroll the page. 14. Stop factor occurred at last Step Offset 1/ 10 3. 10. 5. 7. 2. 7. 8. 4. 1 9. Automatic Offset Current step (red) Number of steps Auto Color Change Offset Minute stitch