Service Documents

Table of contents Chapter 5 Functions concerning embroidery 1. To change color .............................................................................................................................. 70 1-1. To change color manually (Manual Color Change) ............................................................... 70 2. To trim thread ................................................................................................................................. 71 2-1. To trim thread manually (Manual Thread Trimming) ............................................................. 71 2-2. To trim thread automatically (ATH)........................................................................................ 72 2-3. To change thread breakage detecting sensitivity (Thread Detection) ................................... 75 2-4. To trim thread by the number of consecutive jump stitches (Jump Convert)......................... 77 2-5. To add thread trimming code to the design and trim thread (Data Edit "Insert") ................... 78 2-6. To change thread trim timing (ATH Start Timing) .................................................................. 80 3. To set the embroidery speed .......................................................................................................... 81 3-1. To limit embroidery speed by stitch length (Min. Revolution) ................................................ 81 3-2. To change maximum speed only in some section (Revolution Limit).................................... 82 3-3. To decide upper limit value of the maximum speed (Max. Revolution Limit)........................ 83 4. To stop the machine ....................................................................................................................... 84 4-1. To stop the machine automatically when reaching the set value (Preset Halt) .................... 84 4-2. To stop the machine before needle bar hits the frame (Software Frame Limit).................... 85 4-3. To stop the machine with needle bar stuck in the material (Stop at Lower D.Point) ............. 87 4-4. To stop at Frame Limit (Frame Limit setting)......................................................................... 88 5. To change the direction and the size of the design ........................................................................ 90 5-1. To perform enlargement, rotation, reversion (Data Conversion) ........................................... 90 6. To embroider the same design repeatedly ..................................................................................... 92 6-1. To repeat to horizontal and vertical direction (Repeat).......................................................... 92 6-2. To repeat at the same place (A.S. after Auto Data Set) ........................................................ 95 7. To adjust finishing of embroidering................................................................................................. 96 7-1. To adjust driving error of the frame (Backlash)..................................................................... 96 7-2. To adjust stitch length of satin stitch (Satin Stitch) ................................................................ 97 7-3. To divide a long stitch (Auto Jump) ....................................................................................... 98 7-4. To change stitching condition in every needle bar (Setting in units of Needle bar) ............. 100 7-5. To delete minute stitch (Cleanup)........................................................................................ 105 7-6. To change thread tension (Frame Start Timing).................................................................. 106

• Cover