To trim thread
72
Chapter 5
SQ01
2-2. To trim thread automatically (ATH)
It is the setting to trim thread.
2-2-1. Explanation of the screen
[a] To trim thread automatically
YES: To trim
NO: Not to trim thread
[b] Remaining length of upper thread after thread trimming (1 in the
right figure)
When upper thread remains on the fabric, select the value of "-".
If sewing is impossible due to short of remaining length of upper
thread, select the value of "+".
When "N" is displayed, the value differs in each needle bar.
Regarding the setting of needle bar unit, refer to detailed page.(p.100)
[c] Number of lowering the needle bar by slow operation at start after thread trimming or after data
set
F2
YES
9 ATH
YES/NO
N
-5
Inching after ATH
4
2
Return Stitches
NO
1/2/T0/T1/T2/NO
Return Stitch Length
N
A
A/B/C/D
Thread trim length
9
+8
Tie stitches
Tie Stitch Length
N
0.6 2.0 [mm]
0.4
2.0 [mm]
[b]
[c]
[d]
[e]
[f]
[g]
[a]
To trim thread automatically
Remaining length of upper thread
Number of lowering needle bar at slow operation
Return Stitches
Return Stitch Length
Tie stitches
Tie Stitch Length
1
-5 +8
Short Long
0
