To trim thread
80
Chapter 5
QS07
2-6. To change thread trim timing (ATH Start Timing)
This function is for the purpose to improve thread trimming by changing moving timing of the thread trimming
knife.
2-6-1. Explanation of the screen
2-6-2. How to operate
The following is an example that ATH Start Timing is set to "+5°".
(1) To set to main screen
(2) To press F2 key while pressing SET
(3) To press F2 key
(4) To select ATH drive start timing
This machine was shipped after being set to optimum values. To change these values,
consult the distributor. Some operating condition could cause occurrence of fault in thread
trimming.
0
Timing to start moving thread
trimming knife (Value is of main
shaft angle)
4 ATH Start Timing
-5
Fast
+5
Slow
CAUTION
!
SET + F2 screen will be displayed.
4 ATH Start Timing
0
+5
