Mimaki

4 7 Clean the cap rubber. • Wipe off any adhering ink or dust using a cleaning stick or tweezers moistened with maintenance liquid. Wipe off the maintenance liquid. Make sure none remains. 8 Press the [ENTER] key after cleaning. Cleaning the wiper cleaner Wipe off any adhering ink or dust using a cleaning stick or tweezers moistened with maintenance liquid. Remove the lower part of the ink guard when cleaning the wiper cleaner. Press the tabs and pull forward to remove it. Cleaning the wiper ink guard Wipe off any adhering ink or dust using a cleaning stick or tweezers moistened with maintenance liquid. Cleaning under the carriage The underside of the carriage becomes coated with ink wiped off by the wiper. Continuing to use the dirty carriage underside will rub dried ink and attached dust on to the media, resulting in contaminated prints. The print head uses an extremely delicate mechanism. Take great care when handling it. 1 With the screen in local mode, select [MENU] > [MAINTENANCE], and then press the [ENTER] key. • The Maintenance menu is displayed. 2 Select [STATION MAINT.] > [CARRIAGE OUT] > [HEAD MAINT.], and then press the [ENTER] key. • The carriage moves to the maintenance space. • When using tweezers, be careful not to damage the wiper with them. • If ink dry matter adheres to the cap rubber, it may cause cleaning failure. Lugs Cap rubber [TxF150-75] Cap rubber [TxF300-75] Wiper cleaner • Be careful not to pull out the tube. • Be careful to avoid leaving fragments from the cleaning stick behind when cleaning. These fragments will increase the risk of ejection failures (e.g., nozzle clogging or deflection). • Never rub head nozzles. Tabs Ink guard Wiper ink guard Use a cleaning stick or tweezers moistened with maintenance liquid to wipe off ink and dust in the red area of the illustration.

• Cover