Issue link: https://docs.hic.us/i/445631
Contents Chapter 5 Functions concerning embroidery 1. To change color .................................................................................................................... 80 1-1. To change color manually (Manual Color Change) ..................................................... 80 2. To trim thread ....................................................................................................................... 81 2-1. To trim thread manually (Manual Thread Trimming) ................................................... 81 2-2. To trim thread automatically (ATH).............................................................................. 82 2-3. To change thread breakage detecting sensitivity (Thread Detection) ......................... 85 2-4. To trim thread by the number of consecutive jump stitches (Jump Convert) .............. 87 2-5. To add thread trimming code to the design and trim thread (Data Edit "Insert") ......... 88 2-6. To change thread trim timing (ATH Start Timing) ........................................................ 90 3. To set the embroidery speed ................................................................................................ 91 3-1. To limit embroidery speed by stitch length (Min. Revolution) ...................................... 91 3-2. To change maximum speed only in some section (Revolution Limit).......................... 92 3-3. To decide upper limit value of the maximum speed (Max. Revolution Limit) ............. 93 4. To stop the machine ............................................................................................................. 94 4-1. To stop the machine automatically when reaching the set value (Preset Halt) .......... 94 4-2. To stop the machine before needle bar hits the frame (Software Frame Limit) ......... 95 4-3. To stop the machine with needle bar stuck in the material (Stop at Lower D.Point) ... 97 4-4. To stop at Frame Limit (Frame Limit setting)............................................................... 98 5. To change the direction and the size of the design ............................................................ 100 5-1. To perform enlargement, rotation, reversion (Data Conversion) ............................... 100 6. To embroider the same design repeatedly ......................................................................... 102 6-1. To repeat to crosswise and lengthwise direction (Repeat) ........................................ 102 6-2. To repeat at the same place (A.S. after Auto Data Set) ............................................ 105 7. To adjust finishing of sewing .............................................................................................. 106 7-1. To adjust driving error of the frame (Backlash) ........................................................ 106 7-2. To adjust stitch length of satin stitch (Satin Stitch) .................................................... 107 7-3. To divide a long stitch (Auto Jump) ........................................................................... 108 7-4. To change stitching condition in every needle bar (Setting in units of Needle bar) ... 109 7-5. To delete a fine stitch (Cleanup)................................................................................ 113 7-6. To change thread tension (Frame start timing) ......................................................... 114