Issue link: https://docs.hic.us/i/445631
216 Countermeasure when the machine stopped Chapter 9 PT10 316 Main shaft motor error or main shaft driver error Turn "OFF/ON" the power. Or switch from sleep mode to normal mode. (Each driver setting will be reset.) When it is not possible to recover from the trouble, replace the card. 322- Abnormality of X-axis driver Description of mark differs depending on factor. The same is applied to No.323. 323- Abnormality of Y-axis driver 32A The machine cannot memorize excitation of X- axis driver. Turn "OFF/ON" the power. Check connection of each frame driver motor and/or sensor wire. Replace the corresponding frame driver or frame motor. 32B The machine cannot memorize excitation of Y- axis driver. 32C Incompletion of X-axis frame travel Turn "OFF/ON" the power. Or switch from sleep mode to normal mode. (Each driver setting will be reset.) When it is not possible to recover from the trouble, replace the card. 32D Incompletion of Y-axis frame travel 32E The machine cannot complete X-axis origin search within the time. Check setting for embroidery space at software installation. Check the sensor card. 32F The machine cannot complete Y-axis origin search within the time. 331 Abnormal signal of bobbin changer has been detected. Operate the bobbin changer manually after resetting the error, and check/adjust the place where motion error occurred. 353 Abnormality occurred in up/down color change driver (Sequin device III only). Check the card. 354 Sequin/zigzag cord motor, color change motor, ATH motor overcurrent (Color change motor and ATH motor are applicable to single-head machine only.) Turn OFF/ON the power. Check and/or replace the head card. Decrease rpm. 362 Jump motor overcurrent 382 The needle position signal status during color change does not change for 1 second and more. Check the color change motor and power supply circuit. Check the potentiometer (needle position sensor). 383 Needle position was abnormal. Check setting for the number of needles at installation of software. There was no needle position signal during rotation of the main shaft. Check the potentiometer (needle position sensor). 387 Color change motor sensor error Check encoder signal wire of color change motor. 3A6 ATH movable knife retractable position has become nonuniform. Check the position of ATH movable knife. No. Stop Factor How to restore * * *