Issue link: https://docs.hic.us/i/445637
Table of contents Chapter 5 Functions concerning embroidery 1. To change color .................................................................................................................... 76 1-1. To change color manually (Manual Color Change) ..................................................... 76 2. To trim thread ....................................................................................................................... 77 2-1. To trim thread manually (Manual Thread Trimming) ................................................... 77 2-2. To trim thread automatically (ATH).............................................................................. 78 2-3. To change thread breakage detecting sensitivity (Thread Detection) ......................... 81 2-4. To trim thread by the number of consecutive jump stitches (Jump Convert)............... 83 2-5. To add thread trimming code to the design and trim thread (Data Edit "Insert") ......... 84 2-6. To change thread trim timing (ATH Start Timing) ........................................................ 86 3. To set the embroidery speed ................................................................................................ 87 3-1. To limit embroidering speed by stitch length (Min. Revolution) ................................... 87 3-2. To change maximum speed only in some section (Revolution Limit).......................... 88 3-3. To decide upper limit value of the maximum speed (Max. Revolution Limit).............. 89 4. To stop the machine ............................................................................................................. 90 4-1. To stop the machine automatically when reaching the set value (Preset Halt) .......... 90 4-2. To stop the machine before needle bar hits the frame (Software Frame Limit).......... 91 4-3. To stop the machine with needle bar stuck in the material (Stop at Lower D.Point) ... 93 4-4. To stop at Frame Limit (Frame Limit setting)............................................................... 94 5. To change the direction and the size of the design .............................................................. 96 5-1. To perform enlargement, rotation, reversion (Data Conversion) ................................. 96 6. To embroider the same design repeatedly ........................................................................... 98 6-1. To repeat to crosswise and lengthwise direction (Repeat) .......................................... 98 6-2. To repeat at the same place (A.S. after Auto Data Set) ............................................ 101 7. To adjust finishing of sewing............................................................................................... 102 7-1. To adjust driving error of the frame (Backlash)......................................................... 102 7-2. To adjust stitch length of satin stitch (Satin Stitch) .................................................... 103 7-3. To divide a long stitch (Auto Jump) ........................................................................... 104 7-4. To change stitching condition in every needle bar (Setting in units of Needle bar) ... 105 7-5. To delete a fine stitch (Cleanup)................................................................................ 109 7-6. To change thread tension (Frame start timing).......................................................... 110