Learning about the Workspace 19
3 Adjust any of the following units settings.
In the Units of measurement area, select Metric or Imperial as
your unit of measurement.
In the Embroidery Settings Units area, select Millimeters,
Points or Inches to set the units used for stitch length and pull-
compensation values.
In the Units of Density area, select Millimeters, Points or SPI
(Stitches per Inch) as your unit of density value.
4 Click OK to close the dialog and apply the changes.
Grid Settings
You can use the Setting dialog to adjust the spacing of the lines in the
workspace grid. To the to change the grid interval, open the Settings
dialog, click the Grid button, and enter new values in the
Horizontal and Vertical spacing fields.
Absolute density: You can choose to have the density (which is
displayed in the Text area of the Start tab) to be displayed either an
absolute value or a relative value (i.e. + or - the base density or the
design). To show the absolute value, check the Absolute density box;
to show the relative density, uncheck the box.
