Issue link: https://docs.hic.us/i/445658
146 Page P2 Chapter 9 G 18 Presser foot timing Set the main shaft angle where the presser foot will go down to the lower dead point. It is possible to set by all needles in a batch or by needle bar unit. The initial value is 30°. It is not necessary to change this value in usual use. 19 Presser foot stroke mode Set Stroke mode of the presser foot . It is possible to set by all needles in a batch or by needle bar unit. Example: Set Presser foot stroke amount of 3rd needle to 18.0 mm. Setting range Any: All needles in a batch 1st to last needle: Needle bar No. 0 to 60: Presser foot timing (° ) Example: Set Presser foot timing of 3rd needle to 25°. Setting range Any: All needles in a batch 1st to last needle: Needle bar No. A: Automatic M: Manual Example: Set 3rd needle to M. r q Needle bar No.3 G s t 18.0 3 4 2 18Presser foot timing 30 30 25 r q Needle bar No.3 G s t 25° 3 4 2 19Presser foot stroke mode A M A According to maximum speed of the machine, the presser foot will perform Stroke automatically (usual setting). The maximum speed of the machine is limited depending on stroke amount (stroke amount is always fixed). Select "M" mainly when embroidering to thick fabric. r q Needle bar No.3 G s t M QS11