Issue link: https://docs.hic.us/i/445658
74 Moving up and down of presser foot Chapter 5 QS08 5-2. To adjust the height of the presser foot according to the fabric Presser foot lower dead point is changed automatically according to "Frame type" in this machine. It will be necessary to adjust as below depending on the thickness of fabric to use. To use this function, it is necessary to set the operation level to "1" or set "Presser foot setting allowed" to "Yes" after setting the operation level to "3". (→p.178, p.179) [Setting screen] 1. Distance (mm) between the presser foot and the needle plate when the presser foot lowers to the lower dead point 2. Stroke mode of presser foot 3. Stroke amount (mm) of presser foot It is effective only when "Stroke mode" is set to "M". Setting range: 5.0 to 25.0 mm Setting range differs depending on the operation level. 4. Main shaft angle when the presser foot lowers to the lower dead point Setting range: 0 to 60° It is unnecessary to change this value in normal use. (initial value is 30°) Setting range (mm) Operation level 5.0 to 25.0 1 2.0 to 25.0 2 3 Presser foot Needle plate Distance Setting range: 0.3 to 6.3 mm According to maximum speed of the machine, the presser foot will perform Stroke automatically (usual setting). A: The maximum speed of the machine is limited depending on stroke amount (stroke amount is always fixed). Select "M" mainly when embroidering to thick fabric. M: Presser foot setting 2 Lower dead point Stroke Timing Stroke mode 0.3 mm 0.3 mm A 5.0 mm 30 1 2 3 4 6 Stroke means up/down reciprocating motion of the presser foot. F.B.Lower dead point 3.0mm 5