Issue link: https://docs.hic.us/i/445658
208 Chapter 11 Troubleshooting 221 Frame Too Far Left Embroidery frame moved to the limit position (left). (+X direction) Move the frame manually to embroider within the setting of embroidery space. 222 Frame Too Far Right Embroidery frame moved to the limit position (right). (-X direction) Move the frame manually to embroider within the setting of embroidery space. 223 Frame Too Far Front Embroidery frame moved to the limit position (front). (+Y direction) Move the frame manually to embroider within the setting of embroidery space. 224 Frame Too Far Back Embroidery frame moved to the limit position (rear). (-Y direction) Move the frame manually to embroider within the setting of embroidery space. 225 Design size too large Design does not fit within the embroidery space due to the present start position of design. Move the frame manually to embroider within the setting of embroidery space. 251 Lubrication level error Lubrication level is irregular. Supply oil to the lubrication tank. 258 Upper dead point sensor error Upper dead point sensor error detected. Check/replace the upper dead point sensor of color change sequin device. 259 Lower dead point sensor error Lower dead point sensor error detected. Check/replace the lower dead point sensor of color change sequin device/zigzag cording device. 25A Sequin color change sensor failure Color change sensor error detected. Check/replace the color change sensor of color change sequin device. 291 Stop by detecting thread breakage Machine detected upper thread breakage. Check the upper and under threads. Check/ replace the tension base card. 292 Irregular material detected Error occurred on the material feeding of zigzag cording device. Check/replace the material. Check the card, harness etc. of zigzag cording device. 293 Under thread break Machine detected under thread breakage. Check the under thread. Check/replace the tension base card. 294 Absence of material detected Machine detected absence of sequin material. Check/replace the sequin material. 2A1 Thread trimming position adjustment error Adjustment time of thread trimming position was exceeded. Return ATH movable knife to the correct position. Check and replace the thread trimming motor/thread trimming motor encoder. 2B2 TAJIMA complement error Complement error detected in TAJIMA data. The same values (+ and -) of the design data are valid at the same time. Correct the design data. Cord Stop factor Corrective Action QS08