Issue link: https://docs.hic.us/i/852277
23 Chapter 2 Getting Ready to Embroider 2 Initially, only the bobbin case is installed in the rotary hook and you will need to install a bobbin before running the machine. First, take the bobbin case out of the rotary hook. Then, after winding the under thread onto the bobbin, place it in the bobbin case. 1. Open the front cover of the bed. 2. While holding the latch lever of the bobbin case, remove the bobbin case from the rotary hook. 1. While positioning the bobbin so its thread winding direction is clockwise, insert it into the bobbin case, from the right side. 2. Holding the end of the thread, guide the under thread through the slit (1) in the bobbin case. 3. Guide the under thread to the spring edge (2). 2.3 Setting the under thread Caution Make sure to turn off the power switch before you take out or insert the bobbin case. 2.3.1 Removing the bobbin case 2.3.2 Putting the bobbin in place If the thread winding direction is reversed, abnormalities in the sewing will occur. (1) (1) (1) (2) (2) (2)