Issue link: https://docs.hic.us/i/852277
99 Chapter 8 Appendix 8 When a red message screen is displayed These are displayed when settings for the machine are incorrect or it was not operated correctly. They can also be caused by a malfunction in the machine itself or by communication errors. Code Message Measure to take 211 Fixed position signal error Fixed position signal cannot be detected. Trim the thread manually, then return the main shaft to the fixed position. "4.10.3 Trimming the thread manually" If the issue cannot be resolved, contact your sales dealer. 221 Frame Too Far Left The embroidery frame moved to the limit position (left)(+X direction). Move the frame so as to make it possible to carry out embroidery within the limits of the frame. "4.10.1 Moving the frame manually" 222 Frame Too Far Right The embroidery frame moved to the travel limit position (right)(-X direction). 223 Frame Too Far Front The embroidery frame moved to the limit position (front)(+Y direction). 224 Frame Too Far Back The embroidery frame moved to the travel limit position (rear)(-Y direction). 225 Design size too large Design size exceeded the embroidery space. Tap [RESET] and check the position of the frame. 281 Color change error Color change detection time, exceeded. Stop use of the machine and contact your sales dealer. 291 Upper Thread Break The machine detected thread breakage. Check the thread. If the thread is broken, replace the thread. Also, the tension base should be cleaned. If the issue cannot be resolved, contact your sales dealer. "2.2 Threading the upper thread", "2.3 Setting the under thread", "8.2.1 Cleaning the machine" 293 Bobbin Thread Break The machine has detected under thread breakage. Check to see if the bobbin has run out of thread, or if the under thread has broken. If the bobbin has run out of thread, or if there isn't much thread left, replace the bobbin with a new one. If the under thread is broken, replace it. "2.3 Setting the under thread" 2B1 Networking error Not connected with Network Check to make sure that the LAN cable is connected properly, and that the settings on the PC or other devices are appropriate. 2B3 Data found in end code Data is found in end code. Modify the design using the dedicated design creation software or an optional DG product. 2B4 Function code error Function code error 2B7 Data set incomplete Data set is not completed. Select the design first, then start the embroidery. 2B8 Pre-reading buffer error Output data is not ready. Modify the design using the dedicated design creation software or an optional DG product. 2BA Memory capacity exceeded Memory capacity is insufficient. Contact your sales dealer.