Issue link: https://docs.hic.us/i/1518964
Chapter 2 Basic Operations 2-6 7 Raise the clamp lever on the rear of the machine. 8 Insert the roll media into the machine. • Slightly tilt the media so that it can be smoothly inserted into the machine without catching on anything. (1) Pull the media out to around the front edge of the platen. (2) Insert the media between the platen and the pinch rollers. • Pull the media out of the roll so that it can be grasped from the front of the machine. (3) Lower the clamp lever on the rear of the machine. • This holds the media in place. 9 Pull out the roll media. (1) Raise the clamp lever on the front of the machine. (2) Gently pull out the roll media until the locking mechanism is engaged a little. 10 Make the roll media even, and then lower the clamp lever. • Pull out a little at several positions of the media as needed to confirm that the amount pulled out is essentially even, and then lower the clamp lever. 11 Use the media holder to hold the media in place lightly. • Position the media so that it does not protrude on the right end beyond the rightmost pinch roller. • When using thick media, remove the media holder from the media before printing. ＩＮＬＥＴ２ Ｉ ＮＬＥ Ｔ２ ＩＮＬＥＴ１ ＩＮＬＥＴ１ ＬＡＮ ＬＡＮ ＵＳＢ ２．０ Ｕ ＳＢ ２． ０ Ｍ Ｒ １ ４ ８ Ｚ Ｚ Ｍ Ｒ １ ４ ８ Ｚ Ｚ ＵＳＢ ２．０ ＬＡＮ Ｍ Ｒ１４ ８ Ｚ Ｚ • When loading media, align the right edge with the platen groove. Placing media farther right than the groove will make it rise up if it moves obliquely, which may damage the head. • An error message (MEDIA SET POSITION R) is displayed if media is misaligned to the left or right of the standard position. Reposition the media. • When there is no media, use the pinch rollers with the clamp changeover sliders pushed back and the clamp raised. If pinch rollers press against the grit roller during transport, the roller surface may be damaged, which may result in transport problems and image quality problems from roller marks. Media holder Media Media holder Groove Clamp changeover sliders