Issue link: https://docs.hic.us/i/1518964
4-5 1 2 2 4 5 6 Chapter 4 Maintenance 6 Return the wiper to its original position. • Holding the wiper by the lugs at both ends, push it in. 7 Clean the cap rubber. • Wipe off any adhering ink or dust using a cleaning stick or tweezers moistened with maintenance liquid. Wipe off the maintenance liquid. Make sure none remains. 8 Press the [ENTER] key after cleaning. Cleaning the wiper cleaner Wipe off any adhering ink or dust using a cleaning stick or tweezers moistened with maintenance liquid. Remove the lower part of the ink guard when cleaning the wiper cleaner. Press the tabs and pull forward to remove it. Cleaning the wiper ink guard Wipe off any adhering ink or dust using a cleaning stick or tweezers moistened with maintenance liquid. Cleaning under the carriage The underside of the carriage becomes coated with ink wiped off by the wiper. Continuing to use the dirty carriage underside will rub dried ink and attached dust on to the media, resulting in contaminated prints. The print head uses an extremely delicate mechanism. Take great care when handling it. • When using tweezers, be careful not to dam- age the wiper with them. • If ink dry matter adheres to the cap rubber, it may cause cleaning failure. Lugs Cap rubber [TxF150-75] Cap rubber [TxF300-75] • Be careful not to pull out the tube. Wiper cleaner Tabs Ink guard Wiper ink guard Use a cleaning stick or tweezers moistened with maintenance liquid to wipe off ink and dust in the red area of the illustration.