Issue link: https://docs.hic.us/i/1518964
Chapter 2 Basic Operations 2-5 2 2 2 5 6 Loading roll media Load roll media on the roll media hanger on the rear of the machine. 1 Move the roll holder located at the rear of the machine toward the middle of the machine. • Before moving the holder, loosen the roll holder retaining screw. 2 Confirm that the clamp lever is lowered. 3 Move the roll holder to the roll loading position. • Make sure the roll stopper is not caught between the roll stopper arm and the machine. 4 Tighten the roll holder retaining screws. • Check steps 2–3 again. 5 Push the core of the roll media onto the left side of the roll holder. • Push the roll media fully onto the roll holder until it is held securely. 6 Loosen the screw on the right end of the roll holder and push the holder into the core of the roll media. Roll holder retaining screw Roll holder Roll Holder Set Position 3 Inch Roll Media 2 Inch Roll Media R o l l H o l d e r S e t P o s i t i o n 3 I n c h R o l l M e d i a 2 I n c h R o l l M e d i a Reference Roll holder side (rear of machine) Setting position for 2-inch core • Two internal diameters of paper cores are supported for roll media: 2 and 3 inches. • Set the roll holder reference line within the area indicated by the arrows as shown below. If the roll holder is set out of this range, media tension will not be applied when the media is pulled out by hand. Setting position for 3-inch core