Issue link: https://docs.hic.us/i/1518964
Chapter 3 Settings 3-17 1 2 3 4 5 6 Nozzle check flow during printing Nozzles are checked in the following sequence when printing begins. Printing operations when nozzle clogging is determined or errors occur Nozzle clogging is determined Printing is stopped. Errors during nozzle checking Printing is stopped and [Printing Check] is automatically turned OFF. After error recovery, set up [Printing Check] again. • To enable, set [Printing Check] to ON. • Retry and auto nozzle recovery are available when this setting is enabled. 1 Nozzle check Judgment 2 3 Nozzle recovery Nozzle check Judgment 4 Retry Judgment Auto nozzle recovery Judgment Nozzle clogging are detected. If checking indicates that the number of clogged nozzles exceeds the [Judgment Condition] setting, the nozzles are cleaned and rechecked. 5 Nozzle clogging detection If the last step indicates more clogged nozzles than set in [Judgment Condition], the machine determines that printing cannot be continued and stops printing. If more clogged nozzles than set in [Judgment Condition] are detected after nozzle recovery, recovery is repeated. • To enable, set [RETRY COUNT] to 1 or more. Nozzle recovery is automatically performed after nozzle checking and recovery operations. • To enable, set [AUTO NOZZLE RECOVERY] to ON.