Issue link: https://docs.hic.us/i/1518964
Chapter 3 Settings 3-4 • If the correction value to use does not lie in the range of -40 to 40, adjust the printing head height and repeat this process from step 2. 6 Do the same to enter a correction value for pattern 2, and then press the [ENTER] key. Heater The platen incorporates a preheater, print heater, and post-heater. Besides setting the temperature for each, you can set the time until the heater turns off after printing. 1 With the screen in local mode, select [MENU] > [SETUP], and then press the [ENTER] key. • SETUP options are displayed. 2 Select a SETUP option from 1 to 4 and press the [ENTER] key. • The SETUP menu is displayed. 3 Select [HEATER] and press the [ENTER] key. 4 Enter the heater temperatures, then press the [ENTER] key. • Heater selection: Select with [ ] / [ ] • Temperature setting: Set with [ ] / [ ] 5 Select [OFF TIME] and press the [ENTER] key. 6 Set the time until the heater turns off after printing and press the [ENTER] key. Logical seek Modifies carriage operation during printing. 1 With the screen in local mode, select [MENU] > [SETUP], and then press the [ENTER] key. • SETUP options are displayed. 2 Select a SETUP option from 1 to 4 and press the [ENTER] key. • The SETUP menu is displayed. 3 Select [LOGICAL SEEK] and press the [ENTER] key. 4 Select a setting value and press the [ENTER] key. • Setting value: HOST / ON / OFF Drying time These setting items control ink drying time. • SCAN: Set the ink drying time per scan. (In bidirectional printing, the machine pauses for the time set after each outward and return scan.) • PRINT END: Set the ink drying time after printing is fin- ished. 1 With the screen in local mode, select [MENU] > [SETUP], and then press the [ENTER] key. • SETUP options are displayed. 2 Select a SETUP option from 1 to 4 and press the [ENTER] key. • The SETUP menu is displayed. Type of heater Function Preheater Preheats the media before printing to suppress rapid temperature change. Print heater Helps prevent ink bleeding. Post-heater Allows ink to dry after printing. • To give priority to RIP settings, use "Host" as the setting value. • To fully deactivate heating, press [FUNC3] (OFF) in step 3. You can also increase all heating tem- peratures by 10°C by pressing [FUNC1]. • Heaters automatically return to the specified tem- perature if keys are pressed or data is received before the off-time set in step 6 elapses. Forms a straight line at the fourth position from 0 in the positive direction. In this case, the dot position correction value is 4.0. Print direction • "SCAN" as set on machine is identified as "Pause Time per Scan" in RasterLink. • The print end setting cannot be set on the Ras- terLink side. Setting the machine setting to "Host" will print with "Print End=0 min." Unidirectional printing Bidirectional printing Carriage movement with logical seek off Carriage movement with logical seek on Unidirectional printing Bidirectional printing Machine width Red arrow: Carriage movement Print area Machine width Machine width Machine width Red arrow: Carriage movement Print area