Issue link: https://docs.hic.us/i/1518964
4-9 1 2 2 4 5 6 Chapter 4 Maintenance Preparing the machine if it will not be used over extended periods Before leaving the machine idle for a week or more, use the cleaning function designed to be used before storage, which cleans head nozzles and the waste ink draining channel. When leaving the machine for more than 2 days (regardless of the ambient temperature), be sure to clean the "cap edge", "wiper", and " carriage bottom surface" before use. 1 With the screen in local mode, select [MENU] > [MAINTENANCE], and then press the [ENTER] key. • The Maintenance menu is displayed. 2 Select [STATION MAINT.] > [CUSTODY WASH], and then press the [ENTER] key. • The carriage moves over the platen. 3 Clean the wiper and bracket, and then press [ENTER] key. • P.4-4 [Cleaning the wiper and cap] 4 Clean the cap rubber and press the [ENTER] key. • P.4-4 [Cleaning the wiper and cap] • At this time, the channel is cleaned automatically. 5 Press the [ENTER] key. • The carriage moves over the platen, and the cap is filled with maintenance liquid (if the maintenance liquid cartridge is usable). • Check whether the cap is filled with maintenance liquid. • Pressing the [FUNC2] key enables additional filling with maintenance liquid. 6 Set the leaving time, and then press the [ENTER] key. • Setting value: 1–99 (in 1-minute increments) • The nozzles are washed. The machine draws maintenance liquid from the cap. • Cleaning is performed automatically after nozzle washing, after which the cap is filled with maintenance liquid. • Check whether the cap is filled with maintenance liquid. • Pressing the [FUNC2] key enables additional filling with maintenance liquid. 7 Press the [ENTER] key. • Pump tube (ink discharge channel below the cap) washing starts. • If the "Check waste ink" warning message is dis- played, check the waste ink tank. P.4-19 [In case of messages to check waste ink] Tools required for cleaning Check whether [Near End] or [Ink End] is displayed. • Maintenance liquid and ink is aspirated during the washing operation. Washing is not possible if an error occurs during this process. Replace with new ink. Illustration:TxF150-75 • If the maintenance liquid cartridge is usable, suck maintenance liquid into a dropper and fill up the cap with it. Fill up the cap with maintenance liquid on the verge of overflow from the cap. • If the maintenance liquid cartridge is usable, suck maintenance liquid into a dropper and fill up the cap with it. Fill up the cap with maintenance liquid on the verge of overflow from the cap. • Do not turn off the main power supply. Turning off the main power supply will disable the auto- matic maintenance function (including nozzle clogging prevention function and ink discharge channel cleaning function). This increases the risk of ejection failures (such as nozzle clogging or deflection). • Do not leave media loaded on the platen. This may leave irregularities or ripples in the media. Illustration:TxF150-75 Illustration:TxF150-75 Illustration:TxF150-75