Issue link: https://docs.hic.us/i/1518964
3-5 1 2 3 4 5 6 Chapter 3 Settings 3 Select [DRYING TIME] and press the [ENTER] key. 4 Set each setting item, and then press the [ENTER] key. • Scanning setting value: Host or 0.0–9.9 sec. • Print end setting value: Host or 0–120 min. • Item selection: Select with [ ] / [ ] • Time setting: Set with [ ] / [ ] Margin (left/right) Set a non-printing area along the left and right edges of the media. This is an offset value relative to the standard 15 mm margin. 1 With the screen in local mode, select [MENU] > [SETUP], and then press the [ENTER] key. • SETUP options are displayed. 2 Select a SETUP option from 1 to 4 and press the [ENTER] key. • The SETUP menu is displayed. 3 Select [MARGIN / LEFT] or [MARGIN / RIGHT] and press the [ENTER] key. 4 Select a setting value and press the [ENTER] key. • Setting value: HOST / -10 to 85 mm Vacuum fan Sets the force with which the medium is held down. Setting suitable vacuum strength for the media can prevent print errors due to the media lifting up. 1 With the screen in local mode, select [MENU] > [SETUP], and then press the [ENTER] key. • SETUP options are displayed. 2 Select a SETUP option from 1 to 4 and press the [ENTER] key. • The SETUP menu is displayed. 3 Select [VACUUM] and press the [ENTER] key. 4 Select a setting value and press the [ENTER] key. • Setting value: HOST / WEAK / STANDARD / STRONG Feed speed Changes the media feed speed in printing and other tasks. 1 With the screen in local mode, select [MENU] > [SETUP], and then press the [ENTER] key. • SETUP options are displayed. 2 Select a SETUP option from 1 to 4 and press the [ENTER] key. • The SETUP menu is displayed. 3 Select [FEED SPEED] and press the [ENTER] key. 4 Select a setting value and press the [ENTER] key. • Setting value: HOST / 10–200% MAPS MAPS (Mimaki Advanced Pass System) evens out ink ejection at pass boundaries to reduce banding between passes. This function enables you to change the extent to which MAPS is applied. Auto cleaning Can be set so that cleaning is performed automatically after a set number of files, media length, or time to date. This enables consistent printing, with heads kept clean. Three auto cleaning options are available, as follows. • To give priority to RIP settings, use "Host" as the setting value. • Margins cannot be set with the included RIP soft- ware (RasterLink). Setting the machine setting to "Host" when RasterLink is used will print with "Margins for right and left offset value=0 mm." • The margin setting is applied when the media width is detected. • To give priority to RIP settings, use "Host" as the setting value. • When the media holder is used in printing, set- ting the right and left margin to -5 mm or less may cause printing to start on the media holder. • To give priority to RIP settings, use "Host" as the setting value. • Depending on print conditions, the speed may not vary for certain settings. • MAPS provides two setting options: "AUTO" and "MANUAL." Because processing most suitable for the printing conditions is applied with MAPS, normally use the default option of "AUTO." • This function requires Mimaki driver Ver. 4.2.0 or higher. • Changing the MAPS settings may change the color tone. Check the results before use. • MAPS may not be effective when printing cer- tain images. Check the results before use. FILE Auto cleaning is performed after the specified print volume. LENGTH Auto cleaning is performed after the machine has fed the specified length of media. TIME Auto cleaning is performed after the specified time has elapsed.